I originally bought one of these for my partner’s music room because he was using a folding work table, two rolling utility carts, the top half of a dresser hutch, and a sofa side table assembled in an arrangement that sort of looked like a desk and enough was enough. He needed something that was very basic, no fancy drawers or side whatsits, and easy access to cables underneath. But more importantly, it had to be a corner desk that fit in the only spot available and not block part of the side window. I ordered this based mostly on the measurements and that it seemed to be as plain as possible.I am very glad I purchased this desk! It took only about an hour to put together, which included time taking a phone call. The instructions were very easy to follow, save one cross bar that took a few minutes to determine if I had it oriented correctly. It took all morning to disassemble the furniture chaos and wrangle the cables and all afternoon to put everything back the way it was (picture doesn’t show the tower of audio equipment that lives on a platform next to the desk), but assembling the desk happened during lunch, easy peasy.Some advice for anyone who buys this: while it comes with all the tools you need, I found it was a lot easier to assemble with a ratcheting screwdriver and a cordless drill with driver bit. This is especially helpful when it’s time to put the top two pieces on, as there’s a bazillion screws. I drove them in with the cordless drill, then tightened them down with the ratcheting screwdriver.I liked this desk so much that I bought a second one for my office. We have a room that was supposed to be a bedroom, but at some point, the previous owners took a chunk out of it to make a closet for the bedroom, which resulted in an L-shaped tiny room that’s more like a glorified closet and far too small to put even a bed in, much less any other furniture. Of course, what that meant was I would have to assemble the desk inside the room, since there’s no way of getting it in there fully assembled.However, this desk was so easy to assemble, I had no problem assembling it in the small space. The second picture shows the desk in my office; the room is just wide enough for this desk with a slim rolling office cart to the right and a double wide cart to the left. That’s the entire space I had to assemble the desk and I was able to do it with little trouble.I like that the bottom of it is completely open so you can fit anything into the space and get at outlets and cables below without issue. Since it’s so simple, there’s a lot of customization possibilities and plenty of foot room without having to shoehorn into one spot. This comes in handy for my partner, who keeps a couple amps and a rat’s nest of cables under it, with three (one not pictured) monitors on top. I put my stacking file drawers and a trash can under mine with printer on top. Both desks have cat toys that get batted under them, but fortunately the toys are easy to fish out with all that space under there.The desk is also very sturdy. My printer weighs a crap-ton and I have climbed on it to reach something from the wall shelf above. It doesn’t wiggle or shake at all, which will be handy when I have to break out the large format printer that shakes everything it touches.